7430A REV B Norge Dryer Parts List

Door strike (striker)

This is a door strike for your washing machine. It is the piece that activates the door switch once the door is closed. If your washer will not start, will not fill with water, or the door will not open/close you may need to replace the door strike. This part is white in color, made from plastic, and measures approximately 2 1/2 inches. This is a genuine OEM part.

Terminal block kit (bracket)

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or is not heating properly, it is likely an issue with the terminal block and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Ice maker (icemaker asm)

This ice maker assembly is used to make ice in your refrigerator. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold into the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. This kit includes the fill cup, 4-pin wire harness adapter, and a tube. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.

Refrigerator water inlet valve (triple water valve)

When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair. NOTE: This part may appear different than the original but is an authorized manufacturer replacement.

Refrigerator slide-out shelf with glass (shelf assembly, slide-out)

Water inlet valve (use wpl w10408179)

This genuine replacement water inlet valve with tubing supplies water to the ice maker and water dispenser. The valve is 120 volts and 50/60 Hz. If your ice maker is not making ice or no water is coming from the dispenser, you may need to replace this part. The manufacturer has updated the water inlet valve and it no longer includes the removable pre-filter bracket. If you are unable to reuse the old removable pre-filter bracket, order part number WPW10445062. Please remember to disconnect the water and power supply before starting your repair.

Refrigerator crisper pan (pan-crispr)

Dryer high limit thermostat (thrmst-fix)

The three-terminal high-limit thermostat with a terminal extension arm acts as a safety mechanism that keeps the dryer from overheating. When the dryer temperature reaches 221 degrees Fahrenheit, the thermostat will shut off power to the heating element until it drops by 80 degrees Fahrenheit. If your dryer has no heat, takes too long to dry or the thermostat has shorted out, you will need to replace the thermostat. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Lower door closing cam (door closing cam)

The door cam helps keep the door closed in the correct position. The cam is mounted around the door pivot point and is made up of a series of ridges and valleys to help keep the door in position. When you open the door, the cam will raise the door ever so slightly, then drop down into another valley to hold the door open. Then as you close the door again, just before the seal contacts the cabinet, the door will fall into another valley helping to hold the door closed. If your refrigerator uses a door closer, the door should shut all by itself. This part is black in color and made of plastic. This is a genuine OEM part.

Dishwasher tub gasket - gray (door gasket)

The door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking you may need to replace the door gasket. This gray door gasket is made of rubber and is a genuine OEM part.

Main electronic control board (board asm main control)

This board controls the operation of the unit and is located on the back of the refrigerator. The defrost controls are built-in to the control board. If your refrigerator is too hot or cold, will not defrost, runs to long, or the ice maker will not work, you may need to replace the control board. Note: This is a genuine OEM part and has been updated by the manufacturer. It may differ in appearance but will function the same as the original.

Wheel & bushing ass (use 5300809640)

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is made of white plastic, and clips to the dishwasher rack with the included axle/clip. Many of our customers have described this repair as easy, and you will not require any tools to complete it. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.

Drum belt (belt)

This dryer drum belt is 88 3/4 inches long, and is 1/4 inch wide. The belt attaches to the motor pulley and helps rotate the drum as the motor rotates. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Refrigerator door gasket (refrigerator door gasket (white))

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed to keep the cool air inside and prevent warm air from entering. This is a genuine OEM part.

Clutch assembly (use wpl 285785)

The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.